Engineering, 21.02.2020 18:04 Emmaxox715

Implement the function two_year_changesthat takes an array of murder rates for a state, ordered by increasing year. For all two-year periods (e. g., from 1960to 1962), it computes and returns the number of increases minus the number of decreases. For example, the array r = make_array(10, 7, 12, 9, 13, 9, 11)contains 3 increases (10 to 12, 7 to 9, and 12 to 13), 1 decrease (13 to 11), and 1change that is neither an increase or decrease (9 to 9). Therefore, two_year_changes(r)would return 2, the difference between 3 increases and 1 decrease. Hint: Consider using the diff_nfunction

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

You know the right answer?

Implement the function two_year_changesthat takes an array of murder rates for a state, ordered by i...

Questions