Engineering, 22.02.2020 04:01 ADKREBS
Describe why mixtures of liquids and gases, even of the same substance, are NOT ideal gases. Describe which assumptions this mixture violates and draw plots comparing the behavior of these gases on P-v and T-v plots to support your argument. Water in a piston-cylinder system undergoes an isobaric heat addition process. It starts as a saturated liquid at 438.1 K (state 1) and then heat is added. Make sure to indicate the table you used for each of the questions below. What is the enthalpy at state 1? What is the enthalpy when the water reaches a saturated vapor state? What is the enthalpy when the water reaches 700 K? What is the phase?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
Describe why mixtures of liquids and gases, even of the same substance, are NOT ideal gases. Describ...
Questions
Computers and Technology, 12.11.2019 03:31
Spanish, 12.11.2019 03:31
Mathematics, 12.11.2019 03:31
