Engineering, 24.02.2020 18:25 sbm1girl

Shear plane angle and shear strain: In an orthogonal cutting operation, the tool has a rake angle = 16°. The chip thickness before the cut = 0.32 mm and the cut yields a deformed chip thickness = 0.72 mm. Calculate (a) the shear plane angle and (b) the shear strain for the operation.

Answers: 3

Show answers

Another question on Engineering

Engineering, 06.07.2019 03:10

An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

Answer

Engineering, 06.07.2019 05:20

An ideal gas expands in an adiabatic turbine from 1200 k and 900 kpa to 800 k. determine the turbine inlet volume flow rate of the gas, in m'/s, required to produce turbine work output at the rate of 650 kw. the average values of the specific heats for this gas over the temperature range and the gas constant are op 1.13 kj/kg.k, v 0.83 kj/kg k, and r 0.30 kj/kg k

Answers: 2

Answer

Engineering, 06.07.2019 05:20

Two kg of refrigerant 134a contained in a piston-cylinder assembly is initially at 4 bar and 70°c. the refrigerant undergoes a constant pressure process to a final state of a saturated vapor. kinetic and potential energy effects can be neglected. a) show the process on a pv diagram b) determine the work for the process, in kj c) determine the heat transfer during the process, in kj

Answers: 3

Answer

Engineering, 06.07.2019 05:30

Around steel bar, 20 mm in diameter and 400 mm long, is placed concentrically within a brass long. tube which has an outside diameter of 30 mm and thickness 4 mm. the tube is 400 mm the upper end of the vertically placed compound bar is rigidly fixed and a collar is fitted to the bottom end. the application of a load p results in the compound rod storing a total of 5 j of energy.calculate (a) the gradually applied load; (b) the suddenly applied load; (c) the impact load that falls 100 mm and induces 5 j of energy; (d) the instantaneous stresses in both materials; and (e) the instantaneous elongation of the compound rod (egt = 200 gpa and egr = 100 gpa).

Answers: 2

Answer

You know the right answer?

Shear plane angle and shear strain: In an orthogonal cutting operation, the tool has a rake angle =...

Questions