A hole of diameter D = 0.25 m is drilled through the center of a solid block of square cross section with w = 1 m on a side. The hole is drilled along the length, l = 2 m, of the block, which has a thermal conductivity of k = 150 W/m·K. The four outer surfaces are exposed to ambient air, with T[infinity],2 = 25°C and h2 = 4 W/m2·K, while hot oil flowing through the hole is characterized by T[infinity],1 = 330°C and h1 = 50 W/m2·K. Determine the corresponding heat rate and surface temperatures.

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.