Engineering, 25.02.2020 17:53 Nickanderson21

A Diesel cycle engine is analyzed using the air standard method.
Given the conditions at state 1, compression ratio (r), and cutoff ratio (rc) determine the efficiency and other values listed below.
Note: The specific heat ratio and gas constant for air are given as k=1.4 and R=0.287 kJ/kg. K respectively.

T1 (K) = 328
P1 (kPa) = 190
r = 14
rp = 1.3
rc = 1.3

a) Determine the specific internal energy (kJ/kg) at state 1.
b) Determine the relative specific volume at state 1.
c) Determine the relative specific volume at state 2.
d) Determine the temperature (K) at state 2.
e) Determine the pressure (kPa) at state 2.
f) Determine the specific enthalpy (kJ/kg) at state 2.
g) Determine the temperature (K) at state 3.
h) Determine the pressure (kPa) at state 3.
i) Determine the specific enthalpy (kJ/kg) at state 3.
j) Determine the relative specific volume at state 3.
k) Determine the relative specific volume at state 4.
l) Determine the temperature (K) at state 4.
m) Determine the pressure (kPa) at state 4.
n) Determine the specific internal energy (kJ/kg) at state 4.
o) Determine the net work per cycle (kJ/kg) of the engine.
p) Determine the heat addition per cycle (kJ/kg) of the engine.
q) Determine the efficiency (%) of the engine.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

Answer

You know the right answer?

A Diesel cycle engine is analyzed using the air standard method.
Given the conditions at stat...

Questions