Engineering, 26.02.2020 05:12 halohero7

An AISI 1030 hot rolled steel bar has a diameter of 1.5in. For unknown factors including the reliability factor, set equal to 1.

Estimate the:

a. Endurance limit (Se’)

b. Corrected endurance limit in bending and rotation (Se). Assume that there is no axial loading. Assume that component is used at room temperature. Assume that a 50% reliability that the endurance strength of your material is within 8% of the mean value reported is acceptable.

c. Corrected endurance limit for reverse bending without rotation (Se). Assume that there is no axial loading. Assume that component is used at room temperature. Assume that a 50% reliability that the endurance strength of your material is within 8% of the mean value reported is acceptable. Note: the size factor will change compared to previous question.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

You know the right answer?

An AISI 1030 hot rolled steel bar has a diameter of 1.5in. For unknown factors including the reliabi...

Questions