Engineering, 27.02.2020 18:42 tangia

The substance is steam (H2O). NOTE: The purpose of this problem is to illustrate that there are conditions where water vapor is far from ideal-gas behavior. For this reason, in this course, we will always use tables or NIST to determine properties of H2O for all conditions to avoid misuse of the ideal-gas EOS.

a. For the four conditions below, calculate the reduced pressure and the reduced temperature.
HINT: See Appendix E. Based on these values, decide if ideal-gas behavior is reasonable, i. e., that Pv = RiT within +/- 5%.
i. P = 15 MPa T = 1200 K
ii. P = 15 MPa T = 800 K
iii. P = 10 MPa T = 600 K
iv. P = 0.10 MPa T = 600 K

b. Use the generalized compressibility chart (Fig. 2.18 p. 92) to estimate a value of the compressibility factor Z for these conditions. How do these values compare with your thinking in part 1?

c. Use the NIST webbook to determine the compressibility factor Z for steam at the conditions above. How "ideal" is steam at these various conditions? How do these Z-values compare with your estimates from part 2?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

You know the right answer?

The substance is steam (H2O). NOTE: The purpose of this problem is to illustrate that there are cond...

Questions