Engineering, 02.03.2020 17:30 4804102262

A major U. S. manufacturer of HVAC equipment is considering the use of propane as a refrigerant for a residential air conditioner in a hot climate. As a first step, an engineer wants to understand the operating conditions for an adiabatic throttling device that would be used. The design inlet condition is a saturated liquid at a pressure of 18 bar. The engineer would like the throttle outlet condition to be a two-phase mixture at a temperature of 4°C. With this information, determine the exit pressure (kPa) and quality. Depict the process on a P-v diagram showing the dome and appropriate lines of constant temperature. Label the state points and show values of pressure and specific volume on the axes.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Consider two concentric spheres forming an enclosure with diameters of 12 cm and 18 cm the spheres are maintained at uniform temperatures ti-50°c and t2 = 250°c and have emissivities .45 and .8, respectively. determine the net rate of radiation heat transfer between the two spheres per unit surface area.

Answers: 1

Answer

You know the right answer?

A major U. S. manufacturer of HVAC equipment is considering the use of propane as a refrigerant for...

Questions