Engineering, 02.03.2020 21:16 NotCJ9006

A converging-diverging nozzle operating at steady-state has a throat area of 3 cm² and an exit area of 6 cm². Air as an ideal gas with k = 1.4 enters a converging-diverging nozzle operating at steady-state and expands isentropically. The inlet Mach number is 0.2, the inlet temperature is 595 R, the inlet pressure is 77.8 psi, and the inlet mass flow rate is 1 lb. m/s.
If the nozzle is choked, and the diverging portion acts as a supersonic nozzle, determine the mass ow rate, in kg/s, and the Mach number, pressure, in bar, and temperature, in K, at the exit. Repeat if the diverging portion acts as a supersonic diffuser.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?

Answers: 3

Answer

Engineering, 06.07.2019 03:20

An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler

Answers: 2

Answer

Engineering, 06.07.2019 03:30

Abrayton cycle operates with a regenerator on the air-standard with properties evaluated at 400 k. the tem- perature of the air entering the compressor is 350k while the temperature of the air exiting the compressor is 600 k. the temperature of the air entering the turbine is 1600 k. the overall cycle produced 600 kj/kg of net work out. assuming a regenerator effectiveness of 0.8, what is the temperature of the air before heat addition (combustion)? draw this process on a t - s diagram

Answers: 3

Answer

You know the right answer?

A converging-diverging nozzle operating at steady-state has a throat area of 3 cm² and an exit area...

Questions