Engineering, 03.03.2020 04:31 davidebner2248

You are to design a digital communication system to transmit four multiplexed analog signals with bandwidths of 1200 Hz, 900 Hz, 300 Hz and 1500 Hz, respectively. Each analog signal is to be sampled at its own respective Nyquist rates and encoded using linear PCM. The maximum tolerable error for each sample is 1% of the signal's peak voltage (Vo).
(a) What is the minimum PCM word size (bits per sample) required?
(b) What is the minimum transmitted bit rate for each of the sampled signals?
(c) Assume the signals are multiplexed on a sample-by-sample basis (each PCM sample is considered a unit not to be divided between frames). If 10 bits per frame are added for synchronization, what is the minimum frame size required (bits)? How many samples from each signal are included in each frame?
(d) What is the transmitted frame rate of the frame defined in part (c) in frames per second? What is the overall transmitted bit rate of the multiplexed digital communication system (bits per second)?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

You know the right answer?

You are to design a digital communication system to transmit four multiplexed analog signals with ba...

Questions