Engineering, 03.03.2020 17:47 savageyvens

Measure RTTs to the google Web server (www. google. com) for 10 times over 10 minutes in a periodic manner (i. e., one measure at every minute), using the following ping command:

For DOS: ping -n 2 www. google. com (or any other portal server)

For MAC/Linux: ping -c 2 www. google. com (or any other portal server)

(5 pt.) Provide a screenshot that shows ten measured RTTs (one measure at every minute). For every measure, provide date and time information before running ping. If necessary, you can provide more than one screenshot.
For DOS: echo %DATE% %TIME%

For MAC/Linux: date

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

You know the right answer?

Measure RTTs to the google Web server (www. google. com) for 10 times over 10 minutes in a periodic...

Questions