subject
Engineering, 04.03.2020 23:22 jamesgraham577

A tire-pressure monitoring system warns you with a dashboard alert when one of your car tires is significantly under-inflated.
How does this pressure monitoring system work? Many cars have sensors that measure the period of rotation of each wheel. Based on the period of rotation, the car’s computer determines the relative size of the tire when the car is moving at a certain speed.
(a) Derive a mathematical equation that relates the period T of the wheel rotation of the tire radius r and the speed v of the car.
(b) The figure below shows a properly inflated tire (left) and an under-inflated tire (right) of the same car. Estimate the percent change of the period of the underinflated tire compared to the properly inflated tire.
The inflated tire has a radius of 303 mm and the underinflated tire has a radius of 293mm. (Radius is from the ground to center of the wheel.)
(c) Estimate the distance this car would have to travel in order for one wheel to make one more complete rotation than the other. Which will undergo more turns, the under-inflated or the properly inflated tire?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
A tire-pressure monitoring system warns you with a dashboard alert when one of your car tires is sig...
Questions
question
Mathematics, 17.01.2020 06:31
question
Mathematics, 17.01.2020 06:31
Questions on the website: 13722361