Engineering, 05.03.2020 19:59 miguelc2145
A steel loop ABCD of length 5ft and of 3/8" diameter is placed as shown around a 1" diameter aluminum rod AC. Cables BE and DF each 1/2" diameter are used to apply the load Q. Knowing that the ultimate strength of the steel used for the loop and the cables is 70ksi and that the ultimate strength of the aluminum used for the rod is 38ksi. Determine the largest load Q that can be applied if an overall factor of safety of 3 is desired.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
A steel loop ABCD of length 5ft and of 3/8" diameter is placed as shown around a 1" diameter aluminu...
Questions
Mathematics, 17.04.2020 17:04
Biology, 17.04.2020 17:04
