Engineering, 06.03.2020 00:10 susanspagoot6385

The ball has a weight of 15 lb and is fixed to a rod having a negligible mass. If it is released from rest when theta = o degrees determine the angle theta at which the compressive force in the rod becomes zero.

Answers: 2

Show answers

Another question on Engineering

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

Engineering, 06.07.2019 03:30

The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.

Answers: 1

Answer

Engineering, 06.07.2019 05:20

A8-in.-diameter steel shaft is to have a press fit with a 16-in-diameter cast iron hub. both the hub and the shaft are 10 in long. using maximum normal stress theorem and appropriate safety factor, it was identified that the maximum allowable circumferential (a.k.a. hoop or tangential) stress in the hub is to be 7.5 ksi. the moduli of elasticity are 30 x 106 psi for steel and 15 x 106 psi for cast iron. the poisson's ratio for both steel and cast ron is 0.3 and coefficient friction for the two materials is 0.12. determine a. the interference or the original mismatch, 8 b. the maximum axial force required to press the hub on the shaft

Answers: 1

Answer

You know the right answer?

The ball has a weight of 15 lb and is fixed to a rod having a negligible mass. If it is released fro...

Questions