Engineering, 06.03.2020 22:04 hickslily9
Nitrogen at an initial state of 300 K,150 kPa and 0.2 m3is compressed slowly in an isothermal process to a final pressure of 800 kPa. Determine the work done to the nitrogen and the amount of heat transfer during this process.
Answers: 2
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Nitrogen at an initial state of 300 K,150 kPa and 0.2 m3is compressed slowly in an isothermal proces...
Spanish, 25.09.2019 14:10
Chemistry, 25.09.2019 14:10
Mathematics, 25.09.2019 14:10
English, 25.09.2019 14:10
History, 25.09.2019 14:10
Mathematics, 25.09.2019 14:10
Social Studies, 25.09.2019 14:10
History, 25.09.2019 14:10
Biology, 25.09.2019 14:10
History, 25.09.2019 14:10
History, 25.09.2019 14:10
Mathematics, 25.09.2019 14:10