Engineering, 07.03.2020 00:02 gugu1004

An undeformed specimen of some alloy has an average grain diameter of 0.04 mm. You are asked to reduce its average grain diameter to 0.010 mm. Is it possible? If so, explain the procedure you would use to and the name the processes involved. If it is not possible then explain, why?.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Consider a beam traveling through diamond and impinging upon the diamond-air interface. the critical angle of incidence for total internal reflection to occur is closest to the following value: select one: a)-22.50° b)-23.85 c)-24.30 d)-23.40° e)-none of the above

Answers: 3

Answer

You know the right answer?

An undeformed specimen of some alloy has an average grain diameter of 0.04 mm. You are asked to redu...

Questions