Engineering, 07.03.2020 01:44 Ackussinglake63
You have been asked to design a steady state treatment device similar to a continuously mixed reactor to treat toluene in an aqueous waste stream. The flow into the system is 1 m3/hr and the toluene concentration is 10 ppm. The system utilizes a particular type of bacteria that can consume toluene following a first order reaction. The rate constant is 0.1 day-1. If the reactor must treat to an effluent concentration of 1 ppm, how big should it be (Volume)?
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
You know the right answer?
You have been asked to design a steady state treatment device similar to a continuously mixed reacto...
Questions
Mathematics, 17.07.2020 20:01
Mathematics, 17.07.2020 20:01
History, 17.07.2020 20:01
