subject
Engineering, 10.03.2020 04:32 tashkynmurat

A manufacturer of an accelerometer reports a sensitivity of 30 mVpp/G at 100 Hz. The same accelerometer was again calibrated and the sensitivity was determined to be 10.6 mV/G at 100 Hz. What is the most probable source of error for the sensitivity differences?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
You know the right answer?
A manufacturer of an accelerometer reports a sensitivity of 30 mVpp/G at 100 Hz. The same accelerome...
Questions
question
Mathematics, 09.04.2020 01:27
question
Mathematics, 09.04.2020 01:27
question
History, 09.04.2020 01:27
Questions on the website: 13722361