Engineering, 10.03.2020 16:22 yessijessiHaley

Your consulting firm has been asked to study a stretch of the Bluish-Green River in Virginia that is badly polluted. The main point source on this stretch of the river is the Brownsville pickle plant. Below the pickle plant, D. O. levels are so low that there have been repeated fish kills. The ultimate BOD of the untreated pickle plant

wastewater is 120 mg/L. The volumetric flow rate of the plant effluent is 1.35 x 108 L/day. The D. O. concentration in the effluent is 3.0 mg/L. You may assume that there are no other significant inputs of BOD immediately below Brownsville.

Upstream of Brownsville, the Bluish-Green River has a D. O. of 7.9 mg/L and an ultimate BOD concentration of 7.2 mg/L. The river velocity is 20 km/day. The BOD decay rate is 0.25/day and the reaeration rate is 0.59/day. The upstream flow is

4.3 x 108 L/day. Temperature of the river and the effluent wastewater is 15

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Your consulting firm has been asked to study a stretch of the Bluish-Green River in Virginia that is...

Questions