Engineering, 10.03.2020 17:01 greenhusky
A shell and tube heat exchanger must be designed to heat 2.5 kg/s water from 15 to 85 degrees celsius. The heating is to be accomplished by passing hot engine oil, which is available at 160 degrees celsius, through the shell side of the exchanger. The oil is known to provide an average convection coefficient of h0 = 400 W/mK on the outside of the tubes. Ten tubes pass the water through the shell. Each tube is thin-walled, of diameter D = 25 mm, and makes eight passes through the shell.
If the oil leaves the exchanger at 100 degrees celsius, what is its flow rate? How long must the tubes be to accomplish the desired heating?
Answers: 3
, b) 
Another question on Engineering
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
A shell and tube heat exchanger must be designed to heat 2.5 kg/s water from 15 to 85 degrees celsiu...
Questions
Mathematics, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
Geography, 30.01.2020 04:43
English, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
Mathematics, 30.01.2020 04:43
