What torque specs to heads bolts need to be at for a 76 small block chevy

What torque specs to heads bolts need to be at for a 76 small block chevy is given below

Explanation:

1.Always torque bolts in three equal increments

Bolts or PartsLube or SealerTorque to:

Cylinder HeadsEngine oil (blind hole) Sealer (water jacket)65 ft-lbs.

Rocker Studs (screw-in)Engine Oil50 ft-lbs.

2.Intake Manifold to Cylinder Head

3.Torque the head bolts in the same manner in three stages. Start by tightening all the bolts in sequence to 45 pounds of torque, then to 75 and finally to the torque recommended. Depending on the type of head you are installing, the final torque number will be different.

4.Bolts with any signs of damage, no matter how slight, should never be reused. Not only will the bolts eventually fail, but when they do, there is the potential for them to cause damage to your cylinder head. This results in a much more expensive repair than simply replacing the bolts in the first place.

5.The Chevy 350 engine is a 350 cubic inch (5.7-liter) small block V8 with a 4.00 and 3.48 inch bore and stroke. Depending on the year, make and model of a car, horsepower ranges from approximately 145 to more than 370.