subject
Engineering, 13.03.2020 04:15 lefloree

A jet aircraft is traveling down a runway at 75 m/s. The jet engines on the aircraft have a 1 m diameter opening and the air leaving the exit has a temperature of 700 K and is traveling at 300 m/s relative to the jet exit. Determine the thrust produced by each jet engine. Assume that the air entering the engine is at rest relative to the ground (no wind). Draw a schematic of the jet engine and identify your control volume

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
You know the right answer?
A jet aircraft is traveling down a runway at 75 m/s. The jet engines on the aircraft have a 1 m diam...
Questions
question
Mathematics, 03.04.2022 06:50
question
Mathematics, 03.04.2022 06:50
question
Mathematics, 03.04.2022 08:00
question
Mathematics, 03.04.2022 08:00
Questions on the website: 13722359