Engineering, 15.03.2020 00:58 weridness80

A function generator provides digital signalsof different frequencies. To simplify the problem, we assume that this generator allows the user to select one oftworectangular periodic signals. This selection is based on 2 pins:
•If pin 1=High, the output is a rectangular signal ofa frequency of 1KHz
•If pin 2= High, the output is a rectangular signal of a frequency of 10KHz
•If pin 1 and pin2are both Low or High then no signal is generated
To simplify the problem, we assume that all these signals have a duty cycle of 50%.
a)Suggest a block diagram of this function generator
b)Suggest a flowchart of the algorithm
c)Translate the algorithm to a C Arduino code

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

A function generator provides digital signalsof different frequencies. To simplify the problem, we a...

Questions