Engineering, 17.03.2020 03:26 jaays4286
Create a spreadsheet to design and analyze a shaft to support a spur gear. Select gear from a catalog (McMaster Carr is a good one). Set up a shaft design with an appropriate shoulder to locate the gear. In the spreadsheet, create a parametric model that will allow you to modify fillet radii, stock shaft diameter, length of the shaft, etc. The model should be capable of calculating bending stress, and "worst-case" deflection angle and displacement. You may assume the minimum shaft diameter as a constant diameter for deflection purposes. Use the actual diameters for the stress calculations. Provide a write up describing how to use the model.
Answers: 2
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
Create a spreadsheet to design and analyze a shaft to support a spur gear. Select gear from a catalo...
Health, 08.07.2019 22:00
Spanish, 08.07.2019 22:00
Geography, 08.07.2019 22:00
Mathematics, 08.07.2019 22:00
Mathematics, 08.07.2019 22:00
Mathematics, 08.07.2019 22:00
Mathematics, 08.07.2019 22:00
English, 08.07.2019 22:00
Biology, 08.07.2019 22:00
English, 08.07.2019 22:00
Mathematics, 08.07.2019 22:00
Arts, 08.07.2019 22:00