Engineering, 20.03.2020 10:41 dlo2457

A home’s temperature is maintained at 25◦C by an AC system with a COP of 3.2 which cools outside air (38◦C with a 30°C Wet Bulb) to 10 C and injects the cooled air into the home. The 25 C air exits the home. A) draw the process on the attached psychrometric chart. B) If the home gains 50,000 KJ/hr what is the required power in kW? C) How much water is condensed if any? D) Without changing the COP or the heat gain of the home what could be done to lower the power requirement of the AC system and what is the minimum power required?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

A home’s temperature is maintained at 25◦C by an AC system with a COP of 3.2 which cools outside air...

Questions