Engineering, 20.03.2020 10:48 Elephants12

A stainless steel was plunge ground with a 8" silicon carbide bonded abrasive wheel of fine grain and medium density. The infeed used was 0.3310−inch and the work traverse speed was 2.50ipm, and it was felt that the wheel hardness in this application is appropriate. Suppose a 4inch wheel of the same grain size and density is to be used and the new hardness should not be greater than previous in accomplishing the same material removal rate (it means that the wheel should be softer), what should be the limitations on the new infeed and the new traverse speed?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

You know the right answer?

A stainless steel was plunge ground with a 8" silicon carbide bonded abrasive wheel of fine grain an...

Questions

SAT, 24.01.2022 14:30

Develop a logical argument about why it could be harmful for consumers for two companies to have almost complete control of an industry’s market share...