Engineering, 23.03.2020 17:19 cheerleader791
Function inRange = CheckWeight(userWeight) % userWeight: User weight in pounds inRange = 0; % 0 indicates user's weight is not in range % Assign inRange with 1 is userWeight is greater than 100 % and less than or equal to 200 inRange = 1; % 1 indicates user's weight is in range end
Answers: 3
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Function inRange = CheckWeight(userWeight) % userWeight: User weight in pounds inRange = 0; % 0 indi...
Physics, 21.12.2019 07:31
English, 21.12.2019 07:31
Chemistry, 21.12.2019 07:31
Mathematics, 21.12.2019 07:31
Physics, 21.12.2019 07:31
Biology, 21.12.2019 07:31
Mathematics, 21.12.2019 07:31
History, 21.12.2019 07:31
Mathematics, 21.12.2019 07:31
Mathematics, 21.12.2019 07:31
Mathematics, 21.12.2019 07:31
History, 21.12.2019 07:31
Mathematics, 21.12.2019 07:31
History, 21.12.2019 07:31