Engineering, 24.03.2020 23:31 mtropical6753

A 21-tooth pinion rotating at 1800 rpm meshes with a 33-tooth gear in a simple spur gear set. Both pinion and gear are manufactured to a quality level of 9. A reliability of 0.9 has been specified, and the transmitted tangential load is 2800 lb. Conditions are such that Km = 1.7. It is proposed that standard 25-degree, full-depth teeth be used, with both pinion and gear hobbed from an AISI 4140 nitride steel. The diametral pitch is 6, and the face width 2.000 in.
(a) Determine the bending stress using the AGMA equations (for the gear most likely to fail).
(b) In the gearset, which do you expect to fail first - the pinion or the gear?
(c) Determine the pitch diameter of the pinion and pitch-line velocity of the gearset.
(d) Determine the dynamic factor K_v.
(e) Determine the bending geometry factor (J) and application factor.
(f) Determine the size factor (K_s), rim thickness factor (K_B), and idler factor (K_1).
(g) Determine the pinion-tooth bending stress How would you determine the factor of safety? Describe qualitatively.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

You know the right answer?

A 21-tooth pinion rotating at 1800 rpm meshes with a 33-tooth gear in a simple spur gear set. Both p...

Questions