Engineering, 26.03.2020 00:54 denaemarie02

A strip of high-strength steel has a length of 30 cm and cross section of 1 mm × 20 mm. The modulus of elasticity is 200 GPa, and Poisson’s ratio is 0.27. It is subjected to an axial load of 15,000 N, and it is instrumented with two axial strain gages, with R = 120 Ω and a gage factor of 2.10. These two gages are connected into opposite legs of a Wheatstone bridge (R1 and R3). The two fixed resistors are also 120 Ω, and the supply voltage is 2.5 V. The bridge is adjusted to zerovoltage output before the load is applied. Find the output of the bridge with the load applied.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

You know the right answer?

A strip of high-strength steel has a length of 30 cm and cross section of 1 mm × 20 mm. The modulus...

Questions