Engineering, 27.03.2020 02:55 hardwick744

Hot engine oil with heat capacity rate of 4440 W/K (product of mass flow rate and specific heat) and an inlet temperature of 150ºC flows through a double pipe heat exchanger. The double pipe heat exchanger is constructed using a 1.5-m-long copper pipe (k = 250 W/m. K) with an inner tube of inside diameter 2 cm and outside tube diameter of 2.25 cm. The inner diameter of the outer tube of the double pipe heat exchanger is 6 cm. Oil flowing at a rate of 2 kg/s through inner tube exits the heat exchanger at a temperature of 50ºC. The cold fluid, i. e., water enters the heat exchanger at 20ºC and exits at 108ºC. Assume the fouling factor on the oil side and water side to be 0.00015 m2.K/W and 0.0001 m2.K/W, respectively.

The properties of water evaluated at an average temperature at the average inlet and exit temperatures of 20ºC and 70ºC or 45ºC are

rho = 990.1kg/m^3
Cp= 4180J/kg. K
k= 0.637W/m. K
μ= 0. 596 ×10^-3 kg/m. s
Pr = 3.91

Calculate the mass flow rate of water.(Round the answer to three decimal places.)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Hot engine oil with heat capacity rate of 4440 W/K (product of mass flow rate and specific heat) and...

Questions