Engineering, 27.03.2020 04:29 devinmoore8686
Design a circuit with the following criteria. Assume availability of +5V and +9V power sources. i. Input signal that operates between Vin = 0V to +5V, and capable of delivering 0.9mA. ii. Output to control an external 4 ohm grounded load powered by 9V. a) Determine the current applied on the external output load? What type of circuit system do you think you need? b) Draw your designed circuit. Make sure to size passive elements, label actual P/N components, use datasheet values, etc as part of your design process. Must show your work to justify your design.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
Design a circuit with the following criteria. Assume availability of +5V and +9V power sources. i. I...
Questions
History, 16.10.2019 07:30
Mathematics, 16.10.2019 07:30
Geography, 16.10.2019 07:30
Social Studies, 16.10.2019 07:30
Mathematics, 16.10.2019 07:30
Biology, 16.10.2019 07:30
Chemistry, 16.10.2019 07:30
Computers and Technology, 16.10.2019 07:30
