subject
Engineering, 28.03.2020 02:58 samara49

Consider a rectangular wing mounted in a low-speed wind tunnel. The wing model completely spans the test section so that the flow is essentially two-dimensional. If the wing has an NACA 4415 airfoil section and a chord of 0.3 meters, calculate the lift, drag, and pitching moment about the quarter-chord per unit span when the pressure, temperature, and velocity are 1 atm., 303K, and 42 m/sec., respectively. The angle of attack is 8°. What is the moment about the leading edge for these conditions?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 19:10
What is a monomer? how do they form a ploymer from the view point of chemical bonding?
Answers: 1
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
Consider a rectangular wing mounted in a low-speed wind tunnel. The wing model completely spans the...
Questions
question
Mathematics, 14.07.2019 23:10
question
Arts, 14.07.2019 23:10
Questions on the website: 13722363