Engineering, 30.03.2020 20:23 CarlsonB

Why is concrete on its own not a good material to use

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

Engineering, 05.07.2019 10:10

What is the correct way to measure the overall length of a boat? measure from the tip of the bow to the highest point on the gunwale. measure from the tip of the bow in a straight line to the stern of the boat. measure from the tip of the bow in a straight line to the back seat. measure from port to starboard at the boat's widest point.

Answers: 1

Answer

Engineering, 06.07.2019 04:20

Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.

Answers: 1

Answer

Engineering, 06.07.2019 04:30

At steady state, air enters an insulated duct of varying cross-sectional area (similar to a nozzle or diffuser) at 200 kpa, 52°c with a mass flow rate of 0.5 kg/s. at the duct exit, the pressure of the air is 100 kpa, the velocity is 255 m/s, and the cross-sectional area is 2 x 10-3 m^2. assuming an ideal gas model, determine: a)-find the specific volume of the air at the exit, in m3/kg. b)- the temperature of the air at the exit, in k. c)-the velocity of the air at the inlet, in m/s. d)-the inlet cross-sectional area, in m^2.

Answers: 1

Answer

You know the right answer?

Why is concrete on its own not a good material to use...

Questions