Engineering, 30.03.2020 21:00 sswaqqin
Design a full-wave bridge rectifier to supply 12V DC voltage to a resistive load of RL=3Ω at the output, assuming an AC supply with 60 Hz frequency with the following characteristics: a) Unfiltered (without output capacitor) b) Filtered. Design a filter capacitor so that the ripple factor of the output voltage is less than %5. Regularly if you add a filter capacitor, the average output voltage would increase. You should revise the AC supply peak voltage VVmm calculated in (a) to match the average 12V DC requirement. Find and report the final value of VV�
Answers: 2
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
Design a full-wave bridge rectifier to supply 12V DC voltage to a resistive load of RL=3Ω at the out...
Computers and Technology, 04.11.2019 19:31
Physics, 04.11.2019 19:31
History, 04.11.2019 19:31
Mathematics, 04.11.2019 19:31
Mathematics, 04.11.2019 19:31
Mathematics, 04.11.2019 19:31
History, 04.11.2019 19:31
Chemistry, 04.11.2019 19:31
History, 04.11.2019 19:31
Mathematics, 04.11.2019 19:31