Engineering, 31.03.2020 00:26 quianna410

A sleeve made of SAE 4150 annealed steel has a nominal inside diameter of 3.0 inches and an outside diameter of 4.0 inches. It is pressed onto a solid shaft with a medium drive force fit. Specify the class of fit, dimensions for the shaft and sleeve, and calculate the stress in the shaft and sleeve after installation. Use the basic hole system. Is the design acceptable

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

A sleeve made of SAE 4150 annealed steel has a nominal inside diameter of 3.0 inches and an outside...

Questions