subject
Engineering, 31.03.2020 21:47 jetblackcap

A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facility can supply up to 10 Mgal/day of additional water with a BOD of 50mg/L, and a local stream can supply an additional 2 Mgal/day with a BOD of 200 mg/L. After use, the factory discharges the water is used to a local river. The concentration of biochemical oxygen demand (BOD) in the wastewater released to a nearby river must be less than 100mg/L. The cost of water is $1000/Mgal from the water supply facility and $150/Mgal from the local stream. The factory has obtained financing that allows them to spend no more than $3500/day on water.
a. Formulate a systems model and find the minimum cost solution that satisfies all constraints.
b. Then, reformulate the model for minimum discharge BOD solution that satisfies all constraints.
c. Plot the two solutions to the previous problem on a graph that has cost on the horizontal axis and BOD on the vertical axis. Draw a line connecting these two different optima and determine the slope of that line.
d. Propose a new environmental policy that would cause a profit-maximizing factory manager to put in place the BOD-minimizing design.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
You know the right answer?
A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facilit...
Questions
question
Geography, 04.02.2020 08:03
Questions on the website: 13722360