Engineering, 03.04.2020 16:27 rhussein6452

Cylindrical pressure vessels with a radius of 1.0 m are made of aluminum alloy (KIc= 24 MPa√m, σY= 900 MPa). Semi-circular cracks of length 2a, and depth a, may exist in the wall of the cylinder. For these cracks, the stress-intensity factor is given by €KI=σπa, where σis the stressnormal to the crack. These vessels were initially designed to work under constant internal pressure of P= 1.0 MPa, with a 2.0 safety factor on thickness for the leak-before-break consideration. However, due to some emergency these vessels need to be used to support an oscillating axial loadthat varies between 0kN and +3400 kN for at least 10,000 cycles. The Paris law is given by94/1.510() m/cycleIda dNK−=×Δ, where ΔΚIis in MPa. m1/2. To achieve this goal, you plan to do a pressure proof test first. What is the value of such proof-testing pressure? (9.3 MPa)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

Cylindrical pressure vessels with a radius of 1.0 m are made of aluminum alloy (KIc= 24 MPa√m, σY= 9...

Questions