subject
Engineering, 04.04.2020 01:32 liliJ

A section of a freeway ramp has a 4.0% grade and ends at station 127 00 and elevation 138 ft. It must be connected to another section of the ramp (which has a 0.0% grade) that is at station 162 00 and elevation 97 ft. It is determined that the crest and sag curves required to connect the ramp should be connected (the PVT of the crest and PVC of the sag) with a constant-grade section that has the lowest grade possible. Design a vertical alignment to connect between these two stations using a 50-mi/h design speed. Provide the lengths of the curves and constant-grade section.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
You know the right answer?
A section of a freeway ramp has a 4.0% grade and ends at station 127 00 and elevation 138 ft. It mus...
Questions
question
Mathematics, 26.09.2019 02:20
Questions on the website: 13722367