Engineering, 04.04.2020 02:10 elias1019

1. A large opaque plate has a top surface temperature Ts = 150.1 ◦C and is insulated on the bottom side. The top of the plate emits E" = 1090 W m2 and is exposed to air T[infinity] = 195.45◦C with a convective heat transfer coefficient h = 15 W m2·K . Incident to the plate is irradiation G" = 2000 W m2 , of which 1200 W m2 is reflected. (a) Determine the emissivity, absorptivity, reflectivity, and radiosity (in W m2 ) of the plate. (b) Does the plate behave as a gray surface? (c) Determine the net heat flux q 00 (in W m2 ). Specify if this is into or out of the plate. Answer : q 00 net = 390 W m2

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

You know the right answer?

1. A large opaque plate has a top surface temperature Ts = 150.1 ◦C and is insulated on the bottom s...

Questions