Engineering, 07.04.2020 05:47 bricksaspares

The Sierpinski triangle can be implemented in MATLAB by plotting points iteratively according to one of the following three rules that are selected randomly with equal probability. Rule 1: x_n + 1 = 0.5x_n, y_n + 1 = 0.5y_n Rule2: x_n + 1 = 0.5x_n + 0.25, y_n + 1 = 0.5y_n+|( 3)/4 Rule 3: x_n + 1, = 0.5x_n + 0.5, y_n + 1 = 0.5y_n Write a program in a script file that calculates the x and y vectors and then plots y versus x as individual points (use plot (x, y, )). Start with x1 = 0 and y1 = 0. Run the program four times with 10, 100, 1,000, and 10,000 iterations.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

You know the right answer?

The Sierpinski triangle can be implemented in MATLAB by plotting points iteratively according to one...

Questions