Engineering, 08.04.2020 01:23 linnaefoos2183
Given that diameter of shaft is 1.5 inch and its upper and lower tolerance limits are 0.03 inch and 0.04 inch respectively. The diameter of hole is 1.48 inch with upper and lower limits of 0.03 inch and 0.05 inch respectively. Determine the fit for this assembly. (Justify your answer) (5 points)
Answers: 3
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
Given that diameter of shaft is 1.5 inch and its upper and lower tolerance limits are 0.03 inch and...
History, 02.02.2021 05:10
History, 02.02.2021 05:10
Physics, 02.02.2021 05:10
English, 02.02.2021 05:10
Mathematics, 02.02.2021 05:10
Physics, 02.02.2021 05:10
Mathematics, 02.02.2021 05:10
Chemistry, 02.02.2021 05:10
Mathematics, 02.02.2021 05:10
Mathematics, 02.02.2021 05:10
History, 02.02.2021 05:10