Engineering, 11.04.2020 04:50 kianag312

(35 points) Consider an experiment to improve a heat treatment process on truckleaf springs reported in Pignatiello and Ramberg (1985). The heat treatment whichforms the camber (or curvature) in leaf springs consists of heating in a high tem-perature furnace, processing by a forming machine, and quenching in an oil bath. The height of an unloaded spring, known as free height, is an important qualitycharacteristic whose target value is 8 inches. An experimental goal is to make thevariation about the target 8.0 as small as possible.

The five factors listed in Ta-ble 1 were chosen across the various stages of the process:

(A)furnace temperature

(B)and heating time

(C) are from the heating stage, transfer time

(D) is the time ittakes the conveyer to transport the springs from the furnace to the forming ma-chine, hold-down time

(E) is the time that the springs are held in a high pressure

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

(35 points) Consider an experiment to improve a heat treatment process on truckleaf springs reported...

Questions