Engineering, 14.04.2020 16:32 mariamakonteh31

A countershaft in a machine has two pulleys mounted on it for power transmission and is supported by cylindrical roller bearings at the ends. The countershaft runs at 1,500 revolutions per minute. The belt tension on the loose side of Pulley 1 is 15% of the tension on tight side. The pulleys are 50 mm wide. The bearings must have a minimum life of 90,000 hours. Design the shaft, mounting components and bearings. The design will include the following items. (1) Shaft material selection (2) Shaft diameters at critical locations along the shaft (using a factor of safety of 1.5) (3) Selection and design of the components needed for mounting the shaft and bearings (4) Selection and design of bearings (5) A CAD drawing of the shaft layout

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

You know the right answer?

A countershaft in a machine has two pulleys mounted on it for power transmission and is supported by...

Questions