Engineering, 14.04.2020 23:01 runaway173

Convection ovens operate on the principle of inducing forced convection inside the oven chamber with a fan. A small cake is to be baked in an oven when the con- vection feature is disabled. For this situation, the free convection coefficient associated with the cake and its Steel sheet Concrete pad Ts, s Tb Ts Tsur Vs Pelec t s Lo ε Air T[infinity], h , 56 Chapter 1 ! Introduction CH001.qxd 2/24/11 12:03 PM Page 56 pan is hfr ! 3 W/m2 ! K. The oven air and wall are at temperatures T! ! Tsur ! 180)C. Determine the heat flux delivered to the cake pan and cake batter when they are initially inserted into the oven and are at a tem- perature of Ti ! 24)C. If the convection feature is acti- vated, the forced convection heat transfer coefficient is hfo ! 27 W/m2 ! K. What is the heat flux at the batter or pan surface when the oven is operated in the convection mode? Assume a value of 0.97 for the emissivity of the cake batter and pan.

Answers: 3

Show answers

Answers

Answer from: bethzabezarahi

complete question:

attached

2356.11 W/m^2

6100.11 W/m^2

Explanation:

Assumptions:

1. Steady-state conditions.

2. The cake is placed in a large surrounding.

3. Heat flux delivered to the cake is due to convection and radiation.

Case 1

Since convection feature is disabled the mode of heat transfer associated with this situation is through free convection and radiation.

q''(free) = [q''(free convection+q''(radiation) ]W/m^2

= h_free(T_infinty - T_i) + εσ(T_air^4 - T_i^4)

= 3 W/m^2K(180°C - 24°C) + 0.97*5.67*10^-8*[(180+273K)^4 -

(24+273K)^4 ]

= 468 +1881.11

= 2356.11 W/m^2

Case 2

Since convection feature is enabled or activated the mode of heat transfer associated with this situation is through forced convection and radiation.

q''(free) = [q''(forced convection+q''(radiation) ]W/m^2

= h_forced(T_infinty - T_i) + εσ(T_air^4 - T_i^4)

= 27 W/m^2K(180°C - 24°C) + 0.97*5.67*10^-8*[(180+273K)^4 -

(24+273K)^4 ]

= 4212 +1881.11

= 6100.11 W/m^2

1. The total heat flux is is 2.58 times higher when the convection feature is activated. Therefore the cake will bake faster during this condition.

2. The contribution of convection heat flux under natural(free) convection is very low as compared to the contribution during forced convection.

3. The heat transfer due to radiation is same in both the cases.

4. Only 19.9 % of the total heat flux is contributed by free convection in the first case.

5. In the second case 69 % of the total heat flux is contributed by forced convection.

Convection ovens operate on the principle of inducing forced convection inside the oven chamber with

Answer from: Quest

Oh yes igger daddy filled my loose ahοle with your sweet sweet mсum said ronald mcdonald as he spread his sesame covered mcahοle for thanos. thanos slid his throbbing purple ᑕock in to ronald's a. o screamed ronald as he poor hole was torn to bloody shreds. gunga gingagunga gingagunga gingagunga ginga a space ranger appeared making autistuc noises odio a los negros! said buzz lightyear as he aped them both.

Answer from: Quest

Answer: harry styles

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

You know the right answer?

Convection ovens operate on the principle of inducing forced convection inside the oven chamber with...

Questions