subject
Engineering, 15.04.2020 02:10 allytrujillo20oy0dib

Ignore swell and shrinkage for this problem.
An excavator with a 5 cubic yard bucket has a cycle time of 33 seconds. The trucks you have available can be filled in 3 cycles of the excavator (trucks have 15 cubic yards capacity). The trucks take 5 minutes to haul, 45 seconds to dump, and 3 minutes to return to the excavator.
a. Find the number of trucks to balance the output of the excavator. Report your answer to at least 1 decimal place. You can assume 60 minute hours.
b. If you round up the number of trucks, what is the output per 60 minutes?
c. If you round the number of trucks down, what is the output per 60 minutes?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Ignore swell and shrinkage for this problem.
An excavator with a 5 cubic yard bucket has a cy...
Questions
question
Mathematics, 08.01.2021 19:40
question
Mathematics, 08.01.2021 19:40
question
English, 08.01.2021 19:40
question
Mathematics, 08.01.2021 19:40
question
Mathematics, 08.01.2021 19:40
Questions on the website: 13722362