Engineering, 15.04.2020 17:24 vanvalenpeyt

Show how to connect the two circuit building blocks from the previous problem to create a circuit that transforms a priority-encoded input into a one-hot encoded output, where the highest-priority hot signal from the input is the hot signal in the output. For example, if the input to the circuit is WoWiWzW3W4W5W5W7 = 01101010, then the circuit should output yoy1yzysyysyy, = 00000010, because ws is the highest-numbered hot signal in the input. Additionally, your circuit should support the case where no signals are hot, i. e., if WoWiWzW3W4W5W5W7 = 00000000, then the circuit should output yoyzyzy3y4ysycyz = 00000000.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

You know the right answer?

Show how to connect the two circuit building blocks from the previous problem to create a circuit th...

Questions