Engineering, 15.04.2020 20:20 estefaniapenalo

Consider the following sets of values: R = 100 Ω, L = 0.4 H, and C = 0.5 µF. R = 100 Ω, L = 0.4 H, and C = 10 µF. R = 100 Ω, L = 0.4 H, and C = 200 µF. Assume the elements are attached in parallel. For each set of values, answer the following: (a) Is the circuit overdamped, underdamped, or critically damped? (b) What are the roots of the characteristic polynomial? Now assume the elements are attached in series. For each set of values, answer the following: (c) Is the circuit overdamped, underdamped, or critically damped? (d) What are the roots of the characteristic polynomial?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Consider the following sets of values: R = 100 Ω, L = 0.4 H, and C = 0.5 µF. R = 100 Ω, L = 0.4 H, a...

Questions