subject
Engineering, 15.04.2020 23:34 steph2478

Air enters a compressor at 100 kPa and 25 ⁰C. It is compressed to 2 MPa and exits the compressor at 540 K. The compressor is at a higher temperature than the surroundings, therefore 140 kJ is lost to the surroundings (as heat) per kg of air flowing through the compressor. You can neglect the kinetic and potential energy. (a) What is the reversible work? (answer in kJ/kg, as a negative number) (b) What is the irreversibility rate? (answer in kJ/kg)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 19:10
What is creep? what is stress relaxation?
Answers: 1
question
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
question
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
You know the right answer?
Air enters a compressor at 100 kPa and 25 ⁰C. It is compressed to 2 MPa and exits the compressor at...
Questions
question
Mathematics, 14.04.2020 18:16
question
Mathematics, 14.04.2020 18:17
Questions on the website: 13722360