subject
Engineering, 16.04.2020 04:04 sumayyahjj

Isye 6501 Analytics-Success-Stories (among others) contain brief overviews of some major Analytics success stories. In this course project, your job is to think carefully about what analytics models and data might have been required. (1) Browse the short overviews of the projects. Read a bunch of them – they’re really interesting. But don’t try to read them all unless you have a lot of spare time; there are lots! (2) Pick a project for which you think at least three different Analytics models might have been combined to create the solution. (3) Think carefully and critically about what models might be used to create the solution, how they would be combined, what specific data might be needed to use the models, how it might be collected, and how often it might need to be refreshed and the models re-run. DO NOT find a description online (or elsewhere) of what the company or organization actually did. I want this project to be about your ideas, not about reading what someone else did. (4) Write a short report describing your answers to (3).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
Isye 6501 Analytics-Success-Stories (among others) contain brief overviews of some major Analytics s...
Questions
question
Mathematics, 02.11.2020 23:20
question
Mathematics, 02.11.2020 23:20
question
English, 02.11.2020 23:20
Questions on the website: 13722367