Engineering, 16.04.2020 19:49 oopfloop2
The flow rate of air at standard conditions in a flat duct is to be determined by installing pressure taps across a bend. The duct is 0.3 m deep and 0.1 m wide. The inner radius of the bend is 0.25 m. If the measured pressure difference between the taps is 40 mm of water, compute the approximate flow rate.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
You know the right answer?
The flow rate of air at standard conditions in a flat duct is to be determined by installing pressur...
Questions
History, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
History, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
History, 19.05.2021 02:40
Mathematics, 19.05.2021 02:40
